Electrostatic steering of thermal emission with active metasurface control of delocalized modes.

We theoretically describe and experimentally demonstrate a graphene-integrated metasurface structure that enables electrically-tunable directional control of thermal emission. This device consists of a dielectric spacer that acts as a Fabry-Perot resonator supporting long-range delocalized modes bounded on one side by an electrostatically tunable metal-graphene metasurface. By varying the Fermi level of the graphene, the accumulated phase of the Fabry-Perot mode is shifted, which changes the direction of absorption and emission at a fixed frequency. We directly measure the frequency- and angle-dependent emissivity of the thermal emission from a fabricated device heated to 250 °C. Our results show that electrostatic control allows the thermal emission at 6.61 µm to be continuously steered over 16°, with a peak emissivity maintained above 0.9. We analyze the dynamic behavior of the thermal emission steerer theoretically using a Fano interference model, and use the model to design optimized thermal steerer structures.

Colossal Optical Anisotropy from Atomic-Scale Modulations.

Materials with large birefringence (Δn, where n is the refractive index) are sought after for polarization control (e.g., in wave plates, polarizing beam splitters, etc.), nonlinear optics, micromanipulation, and as a platform for unconventional light-matter coupling, such as hyperbolic phonon polaritons. Layered 2D materials can feature some of the largest optical anisotropy; however, their use in most optical systems is limited because their optical axis is out of the plane of the layers and the layers are weakly attached. This work demonstrates that a bulk crystal with subtle periodic modulations in its structure-Sr9/8 TiS3 -is transparent and positive-uniaxial, with extraordinary index ne = 4.5 and ordinary index no = 2.4 in the mid- to far-infrared. The excess Sr, compared to stoichiometric SrTiS3 , results in the formation of TiS6 trigonal-prismatic units that break the chains of face-sharing TiS6 octahedra in SrTiS3 into periodic blocks of five TiS6 octahedral units. The additional electrons introduced by the excess Sr form highly oriented electron clouds, which selectively boost the extraordinary index ne and result in record birefringence (Δn > 2.1 with low loss). The connection between subtle structural modulations and large changes in refractive index suggests new categories of anisotropic materials and also tunable optical materials with large refractive-index modulation.

Correcting thermal-emission-induced detector saturation in infrared spectroscopy.

We found that temperature-dependent infrared spectroscopy measurements (i.e., reflectance or transmittance) using a Fourier-transform spectrometer can have substantial errors, especially for elevated sample temperatures and collection using an objective lens. These errors can arise as a result of partial detector saturation due to thermal emission from the measured sample reaching the detector, resulting in nonphysical apparent reduction of reflectance or transmittance with increasing sample temperature. Here, we demonstrate that these temperature-dependent errors can be corrected by implementing several levels of optical attenuation that enable convergence testing of the measured reflectance or transmittance as the thermal-emission signal is reduced, or by applying correction factors that can be inferred by looking at the spectral regions where the sample is not expected to have a substantial temperature dependence.

Switchable Induced-Transmission Filters Enabled by Vanadium Dioxide.

An induced-transmission filter (ITF) uses an ultrathin metallic layer positioned at an electric-field node within a dielectric thin-film bandpass filter to select one transmission band while suppressing other bands that would have been present without the metal layer. We introduce a switchable mid-infrared ITF where the metal can be "switched on and off", enabling the modulation of the filter response from a single band to multiband. The switching is enabled by the reversible insulator-to-metal phase transition of a subwavelength film of vanadium dioxide (VO2). Our work generalizes the ITF─a niche type of bandpass filter─into a new class of tunable devices. Furthermore, our fabrication process─which begins with thin-film VO2 on a suspended membrane─enables the integration of VO2 into any thin-film assembly that is compatible with physical vapor deposition processes and is thus a new platform for realizing tunable thin-film filters.

Detecting Connected Consciousness During Propofol-Induced Anesthesia Using EEG Based Brain Decoding.

Connected consciousness refers to the state when external stimuli can enter into the stream of our consciousness experience. Emerging evidence suggests that although patients may not respond behaviorally to external stimuli during anesthesia, they may be aware of their surroundings. In this work, we investigated whether EEG based brain decoding could be used for detecting connected consciousness in the absence of behavioral responses during propofol infusion. A total of 14 subjects participated in our experiment. Subjects were asked to discriminate two types of auditory stimuli with a finger press during an ultraslow propofol infusion. We trained an EEG based brain decoding model using data collected in the awakened state using the same auditory stimuli and tested the model on data collected during the propofol infusion. The model provided a correct classification rate (CCR) of [Formula: see text]% when subjects were able to respond to the stimuli during the propofol infusion. The CCR dropped to [Formula: see text]% when subjects ceased responding and further decreased to [Formula: see text]% when we increased the propofol concentration by another 0.2 [Formula: see text]g/ml. After terminating the propofol infusion, we observed that the CCR rebounded to [Formula: see text]% before the subjects regained consciousness. With the classification results, we provided evidence that loss of consciousness is a gradual process and may progress from full consciousness to connected consciousness and then to disconnected consciousness.

Infrared Polarizer Based on Direct Coupling to Surface Plasmon Polaritons.

We propose a new type of reflective polarizer based on polarization-dependent coupling to surface plasmon polaritons (SPPs) from free space. This inexpensive polarizer is relatively narrowband but features an extinction ratio of up to 1000 with efficiency of up to 95% for the desired polarization (numbers from a calculation) and thus can be stacked to achieve extinction ratios of 106 or more. As a proof of concept, we experimentally realized a polarizer based on nanoporous aluminum oxide that operates around a wavelength of 10.6 µm, corresponding to the output of a CO2 laser, using aluminum anodization, a low-cost electrochemical process.

Temperature-independent thermal radiation.

Thermal emission is the process by which all objects at nonzero temperatures emit light and is well described by the Planck, Kirchhoff, and Stefan-Boltzmann laws. For most solids, the thermally emitted power increases monotonically with temperature in a one-to-one relationship that enables applications such as infrared imaging and noncontact thermometry. Here, we demonstrated ultrathin thermal emitters that violate this one-to-one relationship via the use of samarium nickel oxide (SmNiO3), a strongly correlated quantum material that undergoes a fully reversible, temperature-driven solid-state phase transition. The smooth and hysteresis-free nature of this unique insulator-to-metal phase transition enabled us to engineer the temperature dependence of emissivity to precisely cancel out the intrinsic blackbody profile described by the Stefan-Boltzmann law, for both heating and cooling. Our design results in temperature-independent thermally emitted power within the long-wave atmospheric transparency window (wavelengths of 8 to 14 µm), across a broad temperature range of ∼30 °C, centered around ∼120 °C. The ability to decouple temperature and thermal emission opens a gateway for controlling the visibility of objects to infrared cameras and, more broadly, opportunities for quantum materials in controlling heat transfer.

Design considerations for the enhancement of human color vision by breaking binocular redundancy.

To see color, the human visual system combines the response of three types of cone cells in the retina-a compressive process that discards a significant amount of spectral information. Here, we present designs based on thin-film optical filters with the goal of enhancing human color vision by breaking its inherent binocular redundancy, providing different spectral content to each eye. We fabricated a set of optical filters that "splits" the response of the short-wavelength cone between the two eyes in individuals with typical trichromatic vision, simulating the presence of approximately four distinct cone types. Such an increase in the number of effective cone types can reduce the prevalence of metamers-pairs of distinct spectra that resolve to the same tristimulus values. This technique may result in an enhancement of spectral perception, with applications ranging from camouflage detection and anti-counterfeiting to new types of artwork and data visualization.

[Emission Factors and Preliminary Emission Estimates of Air Pollutants from Ships at Berth in the Guangzhou Port].

Three large container vessels over a tonnage of 40×103 t at berth in the Guangzhou Port were selected for determination of air pollutants in exhausts from auxiliary engines to obtain fuel-based emission factors (EFs). The fuel-based EFs for vessels A, B, and C at berth were 3096, 3031, and 3028 g·kg-1, respectively, for CO2; 61.8, 19.9, and 27.0 g·kg-1 for NOx; 8.0, 4.0, and 5.3 g·kg-1 for CO; 31.4, 41.9, and 56.7 g·kg-1 for SO2; 2.4, 1.1, and 1.5 g·kg-1 for PM2.5; and 0.13, 0.09, and 0.17 g·kg-1 for VOCs. With the basic information about ship types, arrival times, and berthing times, the emissions of NOx, CO, SO2, PM2.5, and NH3 from a ship at berth in the Guangzhou Port in 2014 were roughly estimated to be 1231, 226, 1229, 47.6 and 0.04 t, respectively, with ships with a tonnage of 10×103-50×103 t sharing the largest burdens, followed by ships over a tonnage of 50×103 t. Estimated emission of VOCs from ships at berth in the Guangzhou Port was about 33.6 t, with vessels below a tonnage of 3×103 t contributing the most.